office (713) 849-3366
fax (713) 849-3654
toll-free (800) SAY-AAAT
Fig. 584 Adjustable Side Beam Clamp
 |
APPLICATION: Fig. 584 Adjustable Side
Beam Clamps are recommended for use in suspending hanger
rods from the edge of the over-head support beams. The support members are I-beams or wide flange beams. CONSTRUCTION: A Fig. 584 Adjustable Side Beam Clamp consists of two bent flat bars as shown in the diagram above. One end of one flat bar is hooked and the other end of the flat bar has a hole and a slot punched in it as shown. The second flat bar is offset as shown in the diagram and has a hole and a slot punched in it as shown. Both bent flat bars are attached with a bolt and hex nut as shown. The flat bars are carbon steel. FINISHES AVAILABLE: Black, Hot Dip Galvanized or Electro-Plated. ORDERING: Specify figure number, rod diameter, width and thick-ness of flange, name and finish, if other than black. EXAMPLE: Fig. 584, 5/8”, Flange width = 5.25” & thickness = .330”. |
