Two Rod Roller Type Hanger

FIG 812

APPLICATION:  A Fig. 812 Two Rod Roller Type Hanger is used to support piping where  1.) significant movement along the axis of the piping at the support location occurs due to thermal expansion or contraction of the piping,  2.) support is to be provided by two rods attached to a structural member above the pipe and  3.) substantial vertical adjustment of the pipe roll is necessary or desirable.  A Roller Type Hanger allows axial movement of the piping with virtually a negligible amount of frictional resistance to the movement.  In addition, the support remains virtually vertical resulting in very little angular rotation of the support rod.  Vertical adjustment is achieved by changing the elevation of the adjustment nuts and is only limited by the amount of threading on the hanger rods.
CONSTRUCTION:  A Fig. 812 Two Rod Roller Type Hanger consists of a Fig. 806 Cast Iron Pipe Roller, two cast iron sockets, one on each end as shown in the picture, and a carbon steel roll rod.
NOTE:  See size selection chart for assistance in determining the appropriate Two Rod Roller Type Hanger for your application.
FINISHES AVAILABLE:  Black, Hot Dip Galvanized, Electro-Plated or Painted
ORDERING:  Specify figure number, roll size, name and finish, if other than black.
NOTE:  Hanger rods and nuts are to be ordered separately.
EXAMPLE:  Fig. 812, Size 6, Two Rod Roller Type Hanger, HDG.

 

 

Hardware Main

 

FIG 800	FIG 803	FIG 806
FIG 809	FIG 812	FIG 815
FIG 818	FIG 821	FIG 824
FIG 827	FIG 830	FIG 833
FIG 842-57